Tuesday, 04 October 2011 12:07

80W Power Supply for CO2 Laser Tubes Featured

Written by  Machine Thailand
Rate this item
(2 votes)
80W Power Supply for C02 Laser Tubes 80W Power Supply for C02 Laser Tubes 80W Power Supply for C02 Laser Tubes

1. Main Features:

1) Good compatibility: It can be applicable to 80W laser tube of a number of manufacturers.

2) Cutting Type and Sculpting Type: The cutting type has a good power stability and strong adaptability; while the sculpting type has a quick response speed and good engraving effect.

3) Dramatically lengthen the service life of laser.

4) Easy Control: The start and stop of laser can be easily controlled by TTL level. And there are protection switch to test the external water, ventilation, etc.

5) Easy control of laser power: Both 0-5V analog signal and PWM signal can control the laser power.

6) The power supply has the function of open circuit protection: Under the condition of good protective earthing, the power supply can work in open-circuit condition for a short time, which could avoid the damage of laser power supply because of the bursting of laser tube, thereby enhancing the life of power supply.

7) The power supply can take feedback interface which can be used in closed-loop control and testing the working current of laser.

8) The power supply adds a new function, that is timely scene judging which part is damaged, laser tube or laser power.

9) Application: Acrylic sculpture, cut; fabric sculpture, cut; Double-color plate engraving, cut; rubber sheet sculpture, cut, etc.

2. Specification

Input
Input Voltage
AC220V or AC110V(to be specified when placing order)
AC frequency
47—440HZ
Cold Surge Current
≤60A(AC220V Input)
≤30A(AC110 Input)
Current Leakage
≤0.7mA(AC220V Input)
≤0.4mA(AC110V Input)
Output
Maximum Input Voltage
DC 40KV
Maximum Output Current
DC 28mA
Efficiency
≥90﹪(full load)
Mean Time Between Failure (MTBF)
≥10000H
Response Speed
≤1ms(from the switch Signal is given to the output current up to 90% of the setting current)
Control Interface
TTL level switch control; high or low effective level can be chosen (details refer to the control terminal specification)
Pressure-proof
Input-Output, Input-Shell: AC1500V 10MA 60S; Output negative is connected with machine shell.
Protection
can work in open-circuit condition for a short time(Require a good protective earthing and avoid arc between the positive and the machine shell)
Environmental
Operating Temperature:-10~40℃,Relative Humidity (RH):≤90﹪
Cooling Way
Force-Air Cooling (FAC)
Dimension
L×W×H=280*173*97(mm)
Last modified on Tuesday, 04 October 2011 12:27
Machine Thailand

Machine Thailand

Laser Expert of Thailand, Laser Machine Sale, Service & Support

Email: [email protected]

Sale Office, Showroom & Service Center: 120 Moo 11, Ample Tower 11th Floor,Bangna-Trad RD., Bangna,BANGKOK 10260

3D/2D Laser Engraving Crystal Dept.: 164/425 Moo 6 Nhongprue Banglamong, Chonburi, 20150

Leave a Comment or Contact Us Here!

Website: www.machinethailand.com
back to top